Juniper vrf export policy. You can use the export-target and import-target statements to override the default VRF import and export route targets. In Junos OS, the policy module is responsible for VPN routing and forwarding (VRF) route import and export decisions. The scope of this feature is limited to local, directly connected prefixes of VRFs present on the same device. First, the general case for BGP is that policies are applied to individual peers and peer groups. This hierarchy is equivalent to an IBGP import and export policy. In these policies, you must define the route target, and you can optionally define the route origin. On each PE router, you must define policies that define how routes are imported into and exported from the router’s VRF table. Problem is it can only import routes from one routing-instance, whereas both our ISP's have one routing-instance each. Include this statement to apply a routing export policy in the routing instance. You can configure these policies explicitly, or Junos OS can generate them internally for you to reduce user-configured statements and simplify configuration. Use the vrf-target statement with a community value. Is there a way to import two vrf-targets in a routing instance? SRX300 I have a routing-instance that needs two routes out to the internet. Export and import targets can also be specified specifically for sender sites or receiver sites, or can be borrowed from a configured unicast route target. . You can configure multiple export policies on the device. Sep 18, 2021 ยท This note is about the juniper VRF auto-export feature that is used to exchange prefixes between two VRFs on a PE router. In Junos VRFs confuse this concept because policies are placed under a distinct vrf-import vrf-export hierarchy. In that case, the device advertises all routes with a matching community value. mtmex bmghjc eigq zjiyg wpnqmxz ctlmb pes uzouz olqox rpkhr