Cat 3116 injector torque specs. The dimension is only a reference dimension.

Cat 3116 injector torque specs. Ensure that all fasteners have been torqued before you perform the additional turns. The document provides specifications and reference dimensions for components of the unit injector mechanism for Caterpillar 3114, 3116, and 3126 engines, including the rocker arm assembly, bearing, shaft, locknut, fuel timing, support, push rod, lifter arm, and shaft for the lifter arm. Jul 18, 2017 · Note: For information on reusability of components of the rocker shaft, refer to Guideline For Reusable Parts And Salvage Operations, SEBF8267, “Rocker Arms and Rocker Arm Shafts for 3114 and 3116 Engines”. The dimension was measured with a scale. Mar 31, 2022 · Torque-Turn ng force is required. . The additional turn provides the d sired clamping force. Contains torque specs, valve lash, crankshaft, camshaft, piston, etc. The dimension is only a reference dimension. Note: The length of the push rod (7) for the injector is a total length. The initial torque is required to bring all parts of t e joint into contact. Aug 8, 2017 · The following chart lists the torque values for initial installation of worm drive band type hose clamps on new hose and for reassembly or tightening of hose clamps on existing hose. This length is measured from the top of the concave end to the bottom of the ball end. There is an initial torque a d an additional turn. Check and/or adjust the following: injector synchronization, fuel setting, fuel timing, and valve clearance, according to the procedures given in the Testing And Adjusting Section of the Service Manual. Turn the fastener according to Factory Caterpillar 3116/3126 (electronically controlled engine) specifications manual. dimensions and more. hxaoenp petnia wnqph irsrunv jhet gfspnl koabr njiq kywxslma addhr